No Canned Cycles

Talk everything about the Vpro Machinist - Make it better
Post Reply
Byron
Posts: 0
Joined: Thu Jul 06, 2017 10:19 am

No Canned Cycles

Post by Byron » Thu Jul 06, 2017 11:12 am

After I purchased the app' I find that I do not have the page for Canned Cycles. Was my download complete? The last routine in the Program Lathe is ID Radius and Angle.

Vpro
Site Admin
Posts: 6
Joined: Fri May 26, 2017 5:24 pm

Re: No Canned Cycles

Post by Vpro » Thu Jul 06, 2017 8:16 pm

Byron wrote:
Thu Jul 06, 2017 11:12 am
After I purchased the app' I find that I do not have the page for Canned Cycles. Was my download complete? The last routine in the Program Lathe is ID Radius and Angle.
ID Radius and Angle is last program. I will update some Cannned Cycles program for next update. Thanks so much for your support.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest